A levelling kit raises only the front of a 4x4 to remove factory rake or correct a nose down stance, usually with front spacers. A lift kit raises the whole vehicle with new springs and shocks. If your front sags from a bull bar or winch, a height adjustable lift kit levels the vehicle and supports the weight at the same time.

Plenty of utes and wagons sit at an odd angle, either nose up from the factory or nose down once accessories go on. A levelling kit is often the first fix people find, but it's not always the right one. Below we explain the difference between levelling and lifting, why vehicles sit unevenly and how to get a level stance that lasts. For a kit that levels and supports load, see our height adjustable lift kits.

Why Do Utes and 4x4s Sit Unevenly?

Most utes leave the factory with rake, meaning the rear sits higher than the front. That's deliberate, because the rear springs are designed to squat level once a load goes in the tray, but empty, the nose looks low.

The opposite happens once accessories are fitted, as a steel bull bar and winch add significant weight to the front, compressing the factory springs and dropping the nose. Add a canopy, drawers and touring gear, and the rear drops too.

The cause matters, because the fix for factory rake is different to the fix for a sagging, overloaded front end.

What Is a Levelling Kit?

This type of kit raises the front of the vehicle to match the rear, usually with spacers fitted above the front struts or coils. It typically adds around 25mm to 50mm at the front only, leaving the rear unchanged.

You'll also see them listed as a leveling kit, the American spelling used on many imported products. Levelling kits are popular because they're simple and affordable. They suit an unloaded vehicle where the only goal is to remove factory rake for looks or a little extra front clearance.

They don't change the spring rate or the shocks, so they don't help a front end that's sagging under weight.

What Is a Lift Kit?

A lift kit raises the whole vehicle by replacing the springs and shocks at both ends with components designed to sit higher. Because the springs are rated for real loads, the vehicle holds its height with accessories fitted, and new shocks control the extra travel.

A height adjustable lift kit goes one step further. The front ReadyStruts let your fitting dealer set the front height within a range, so the vehicle can be levelled to match the weight it actually carries. If you add a winch later, the front can be raised again without new parts. We explain the mechanism in how height adjustable suspension works on a 4x4.

Levelling Kit vs Lift Kit: Which Should You Choose?

The right choice depends on why the vehicle sits unevenly and how it's used.

•        Factory rake on an empty ute: A levelling kit can do the job if the vehicle stays light.

•        Front sag from a bull bar or winch: A lift kit with springs rated for the extra weight, ideally height adjustable, is the lasting fix.

•        Touring or towing with a loaded rear: A full lift kit keeps both ends at the right height under load.

•        A build still being added to: Height adjustable struts let the stance be corrected as each accessory goes on.

If you're carrying weight, levelling with spacers just raises a sagging spring higher in its travel, so the vehicle can still bottom out and wallow.

For most working and touring 4x4s, a height adjustable lift kit is the better long term answer, backed by our 5 year / unlimited km warranty.

Levelling Kit vs Lift Kit Compared

Feature

Levelling kit

Height adjustable lift kit

Where it lifts

Front only

Front and rear

Parts replaced

None, spacers added

Springs, shocks and front struts

Supports accessory weight

No

Yes

Adjustable later

Swap spacers

Reset front height

Best suited to

Removing rake on light vehicles

Accessories, touring and towing

FAQs

Looking for more information about levelling kits and lift kits? Below we answer the most commonly asked questions

What is the difference between a levelling kit and a lift kit?

Levelling kits raise the front only, usually with spacers, while a lift kit raises the whole vehicle with new springs and shocks.

Will a levelling kit fix front sag from a bull bar?

It will raise the nose, but it won't support the extra weight because the factory spring stays in place. Our guide on coil springs for a bull bar and winch explains the proper fix.

Should a ute sit level?

Many owners prefer a level stance, but a little rake helps a ute sit level once the tray is loaded. Set the height to suit how you usually drive.

Do I need an alignment after levelling my 4x4?

Yes, raising the front changes camber, caster and toe, so an alignment is needed after any levelling or lift.

Are levelling kits legal?

Levelling within your state's basic limit is generally permitted. See is a 3 inch lift legal in QLD for details.

Is a strut spacer a levelling kit?

Many levelling kits use strut spacers, and you can compare them with full struts in strut spacers vs adjustable struts.

For a level stance that holds up under load, choose from our height adjustable lift kits.