To adjust coilover height on a 4x4, measure the current ride height, support the vehicle safely, move the spring seat up or down within the strut's range by the amount needed, then lower the vehicle, settle the suspension and measure again. Every height change needs a 4x4 wheel alignment, so it's best handled by a workshop.
Height adjustable coilovers and struts give you the freedom to fine tune your 4x4's stance as your build changes. Knowing how the adjustment works helps you brief your fitter accurately and understand what happens to the vehicle when the height moves. Below we walk through the process step by step. To find adjustable struts for your vehicle, browse our height adjustable lift kits.
What Changes When You Adjust Coilover Height?
A coilover or strut holds the coil spring on a seat, and the position of that seat sets the ride height. Moving the seat up compresses the spring further at rest and raises the vehicle, while moving it down does the opposite.
The spring rate stays the same, so the stiffness of the suspension doesn't change, only where the vehicle sits within its travel. That's why the right setting depends on the weight your front end carries, which we explain further in what spring preload does.
Changing height also moves camber, caster and toe, so every adjustment is followed by an alignment.


Step by Step: Adjusting Coilover Height
The exact process depends on whether the strut uses a threaded collar or circlip positions, and on the kit's instructions. In general, the steps look like this:
1. Measure first: With the vehicle on level ground and loaded as normal, measure from the centre of each wheel to the guard lip and record both sides.
2. Decide the change: Work out how much height you need, keeping within the strut's range and your state's legal limits.
3. Support the vehicle: Raise it on a hoist or rated stands so the front wheels hang free and the spring is unloaded.
4. Access the spring seat: On some designs the seat can be adjusted with the strut fitted and the weight off. On others, the strut must be removed and the spring compressed.
5. Move the seat: Wind a threaded collar or relocate the circlip by the amount needed, making the same change on both sides.
6. Refit and settle: Lower the vehicle, roll it back and forth and bounce the suspension so it settles.
7. Measure again: Compare left and right and fine tune if needed.
8. Align the vehicle: Book a 4x4 wheel alignment to reset camber, caster and toe.
If the strut needs removing and the spring compressing, leave it to a workshop with proper equipment.
How Much Should You Adjust the Height?
Start with what the vehicle weighs as it's actually driven. A bull bar and winch add weight over the front axle, so a strut set before they were fitted often needs raising afterwards. Larger tyres may need a few extra millimetres at the front to clear at full lock.
Most owners land near the middle of their kit's range, which leaves room to go either way later. Avoid winding the seat to the very top just for height, because heavy preload can reduce droop travel and make the ride harsher off road.
Height also counts toward legal limits, so keep total lift within your state's allowance. Our guide on how much lift your 4x4 actually needs helps narrow down the right number.
Adjusting Height on Our ReadyStruts
Our height adjustable ReadyStruts arrive pre assembled with the height preset for the kit. Your fitting dealer sets the final position during installation to suit your vehicle, then aligns it. If your build changes later, the dealer can reset the height within the kit's range rather than replacing parts.
Every kit is backed by our 5 year / unlimited km warranty. Learn more about how the system works in how height adjustable suspension works on a 4x4.
Coilover Height Adjustment Checklist
|
Check |
Why it matters |
|
Measure before and after |
Confirms the change and left to right balance |
|
Stay within the strut's range |
Protects the strut and spring from damage |
|
Match both sides |
Prevents the vehicle leaning or pulling |
|
Settle before measuring |
Springs sit differently straight after lowering |
|
Stay within legal limits |
Avoids certification issues |
|
Book an alignment |
Resets geometry and protects tyres |
FAQs
Looking for more information about adjusting coilover height on a 4x4? Below we answer the most commonly asked questions
Can I adjust coilover height myself?
Does adjusting coilover height change the ride?
Do I need an alignment after adjusting coilover height?
How often can I adjust coilover height?
Why is my 4x4 leaning after adjusting height?
Can I level my 4x4 by adjusting coilover height?
To set your 4x4's stance just right, choose from our height adjustable lift kits.

